3Racing GRAP-2010 Racing Grade 1.0mm Graphite Plate  [GRAP-2010]

3RACING 1.0mm Woven Graphite Plate (1.0 x 450 x 600mm) - GRAP-2010
Price:
USD$93.20
Brand:
3Racing
Model:
GRAP-2010
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Racing Oriented Woven Graphite Sheet

The 3Racing GRAP-2010 is a precision 1.0mm woven graphite plate sized 450 x 600mm, intended for racers and tuners seeking consistent flex characteristics. The weave pattern provides repeatable torsional response for fine setup work.

Performance Focus for Tuning

In racing contexts, predictable chassis rigidity is key. The GRAP-2010 offers uniform stiffness across the sheet so you can compare setup changes and evaluate handling differences with minimal material variance.

Practical Notes for Competitive Builds

Use the full sheet to create custom braces, top decks, or chassis reinforcement with minimal added mass. Trial different mounting layouts to influence roll centre and yaw behaviour, then standardise the configuration that best suits your vehicle and track.

What is the best way to evaluate chassis stiffness changes?

Fit the GRAP-2010 in candidate locations and perform back-to-back test runs, changing only one variable at a time to quantify handling differences in lap times or driver feedback.

Should I combine this plate with aluminium braces?

Yes, combining the GRAP-2010 with lightweight aluminium supports can localise stiffness where required while keeping overall mass low. Validate hole patterns and clearances before final assembly.

Any recommended prep before installation?

Deburr cut edges, clean with isopropyl alcohol, and trial-fit fasteners. For bonded joints use a thin, high strength epoxy and allow full cure before track testing.