3RACING BAT-CA1212/MX 12AWG Performance Silicone Lead 12 inch  [BAT-CA1212/MX]

3RACING 12AWG Silicon Cable Set (12 inch) - BAT-CA1212/MX
Price:
USD$5.70
Brand:
3Racing
Model:
BAT-CA1212/MX
Condition:
Brand New
Write a review

Technical overview for 3RACING BAT-CA1212/MX wiring

The 3RACING BAT-CA1212/MX 12AWG Silicone Cable Set is aimed at hobbyists focused on reliable power delivery and tidy race wiring. The 12 inch length is well suited to common chassis layouts and allows neat solder joints without excess slack.

Performance and installation notes

  • Durability: Silicone insulation endures vibration and repeated flexing during racing use, lowering the chance of insulation fatigue.
  • Flexibility: High-strand conductor and soft jacket enable controlled routing with minimal stress at termination points.
  • Compatibility: Suitable for a wide range of ESC and motor pairings; use correct soldering practice and heatshrink to maintain low resistance joints.

Is the 12AWG conductor adequate for high amp draws?

Yes, 12AWG is commonly used for high-current circuits in RC racing. Ensure soldered joints are solid and connectors are rated for the intended current to avoid voltage drop.

Best soldering practice for optimal conductivity?

Tin the strands, heat the connector and wire evenly, apply solder to the heated joint, and then insulate with tight shrink tube to prevent movement and corrosion.

Any chassis routing tips for racing setups?

Keep power runs short, avoid sharp bends near joints, secure cables away from moving parts, and separate power wiring from signal wiring where possible to reduce interference.