3RACING 3RAC-PN2012 2 x 12mm Steel Pins 5pc Racing Spare Kit  [3RAC-PN2012]

3RACING 2 X 12mm Steel Pin - 5pcs - 3RAC-PN2012
Price:
USD$1.30
Brand:
3Racing
Model:
3RAC-PN2012
Condition:
Brand New
Write a review

Precision Linkage Pins for Competitive Use

The 3RACING 3RAC-PN2012 2 x 12mm steel pins come as a five-piece set designed for consistent fit and repeatable performance in race setups. These pins are intended to minimise play in steering and suspension pivots, supporting predictable chassis behaviour during tuning sessions.

Technical Fit and Application

These pins suit models that accept 2mm by 12mm shaft pins and are commonly used in tie rods, suspension arms, and other small pivots where tight tolerances matter. Use them to replace deformed or fatigued pins and to maintain alignment after suspension changes.

Material Properties and Maintenance

Manufactured from hardened steel, the pins offer high wear resistance and reliable dimensional stability under load. For optimal service life, check seating surfaces for burrs, apply light corrosion protection if required, and replace pins showing any bend or excessive wear.

What checks should I perform when swapping pins?

Verify the receiving bore is clean and free of damage, confirm the 2 x 12mm dimensions, and ensure the pin seats fully to avoid introducing axial play into the assembly.

How do these pins affect handling consistency?

Replacing worn pins with true-dimension pins like the 3RACING 3RAC-PN2012 reduces unwanted movement at pivot points, which helps keep setup changes consistent lap to lap.

Are there any recommended lubrication practices?

Use a light corrosion inhibitor or thin oil on metal-to-metal pivots if conditions are damp; avoid heavy greases that can trap debris and accelerate wear.