3RACING 3RAC-AD12/V2 Gold Realistic Front Brake Disk Racing Detail  [3RAC-AD12/V2A/GO]

3RACING Realistic Front Brake Disk For 3RAC-AD12/V2 - Gold - 3RAC-AD12/V2A/GO
Price:
USD$7.50
Brand:
3Racing
Model:
3RAC-AD12/V2A/GO
Condition:
Brand New
Write a review

Racing oriented scale rotor for 3RAC-AD12/V2 setups

The 3Racing Realistic Front Brake Disk in gold is produced to give a race-style visual upgrade while keeping installation straightforward. It is dimensioned to work with the 3RAC-AD12/V2 arrangement and balances scale detail with minimal added mass.

Compatibility and fit

Engineered to match common 1/10 on-road hub spacing, the disk offers a close visual match to full-size rotors. Fitment requires standard hub screws and does not demand chassis changes, so it integrates smoothly into tuned setups.

Fitment procedure and handling

Install by aligning the disk to the hub, thread the recommended screws to manufacturer torque guidelines, and verify wheel spin clearance. For track use, inspect mounting hardware regularly and replace any fasteners that show wear.

What hub measurements are critical for fit?

Measure hub bore diameter and flange offset; the disk assumes standard 1/10 hub bore and a typical flange thickness. Confirm these before ordering for a precise fit.

Should I balance wheels after fitting the disk?

For competition it is good practice to check wheel balance after installing any accessory. The disk adds negligible weight, but checking ensures predictable handling at speed.

Are torque specs different with this disk installed?

Use the same hub torque values recommended by your chassis manufacturer. Avoid over tightening to prevent distortion of the disk or hub interface.