3Racing 3RAC-BE4816/V2 Racing Ball Ends for Sakura D3 CS SPORT 4.8mm  [3RAC-BE4816/V2]

3RACING Sakura D3 CS SPORT 4.8mm Ball End Set - 16mm & 12mm /V2 - 3RAC-BE4816/V2
Price:
USD$2.50
Brand:
3Racing
Model:
3RAC-BE4816/V2
Condition:
Brand New
Write a review

Race-Oriented Ball End Solution for Sakura D3 CS SPORT

The 3Racing 4.8mm ball end set is specified for the Sakura D3 CS SPORT to offer two discrete lengths, 16mm and 12mm, that assist in setting roll centre and tie-rod geometry. These components are intended to provide predictable joint behaviour under dynamic loads common in competitive drifting.

Engineering Focused for Tuners

Manufactured to maintain tight tolerances, the 3Racing ball ends reduce unwanted compliance in the steering and suspension linkages. Consistent joint characteristics support repeatable setup changes and quicker track tuning cycles.

Compatibility and Setup Notes

These ball ends match the Sakura D3 CS SPORT linkage layout, allowing straightforward installation into stock or upgraded turnbuckles. Use the two lengths to experiment with understeer and oversteer balance while documenting changes for rapid iteration.

What tuning changes result from swapping the 16mm and 12mm lengths?

Changing link length alters leverage on the suspension and can shift initial turn-in and mid corner balance. Record baseline settings and adjust one end at a time to isolate effects.

Any recommendations for break-in or bedding?

Cycle the joints through their range under light load to seat mating surfaces before competitive use, then recheck for play. This reduces early wear and keeps handling consistent.

What inspection routine suits regular race use?

Inspect for radial play, surface scoring and thread integrity after each event. Replace any item showing measurable play to maintain precise steering response.