3Racing 3RAC-BS4806S Racing Grade Steel Ball Studs for Sakura D3 CS SPORT  [3RAC-BS4806S]

Race-Focused 4.8mm Steel Ball Studs

The 3Racing 3RAC-BS4806S ball studs are specified for competitive Sakura D3 CS SPORT rigs where repeatable geometry and minimal compliance are required. Manufactured from hardened steel for consistent seating in ball cups, the 4.8mm diameter and 6mm length maintain roll centre and steering characteristics lap after lap.

Technical Highlights

• Material: Heat treated steel to resist deformation under high load conditions.
• Size: 4.8mm outer diameter with 6mm effective length to match D3 suspension dimensions.
• Compatibility: Direct replacement for Sakura D3 CS SPORT suspension ball studs.
• Quantity: 10 pieces per pack to facilitate full-arm replacement and spares for race days.

Setup Guidance for Tuners

Use these studs when fine tuning camber and roll centre; they reduce slop at pivot points and enable more precise dialling of steering response. Inspect mating ball cups and replace any worn components to fully benefit from the studs mechanical stiffness.