3Racing 3RAC-BW03 Race-Grade Pre-Cut Balance Weights  [3RAC-BW03]

3RACING Balance weight (pre-cut) with graphite pattern - 5g and 10g - 3RAC-BW03
Price:
USD$3.80
Brand:
3Racing
Model:
3RAC-BW03
Condition:
Brand New
Write a review

3Racing 3RAC-BW03 Technical Balance Weight Overview

The 3Racing 3RAC-BW03 balance weights provide a straightforward method for adjusting mass distribution during setup work. Available in 5g and 10g increments with a graphite-pattern finish, these pre-cut parts let tuners introduce repeatable weight changes without fabrication.

Material Finish and Integration Notes

The graphite pattern offers a durable surface that suits visible mounting areas and internal reinforcement points alike. Their flat profile simplifies placement against flat chassis surfaces, allowing precise shifts in fore-aft or lateral balance with minimal alteration to the chassis.

Tuning Strategy and Practical Use

Use 5g units for incremental adjustments when trimming understeer or oversteer, and move to 10g where larger mass shifts are required. Document each change and test in consistent conditions to evaluate corner entry, mid corner stability, and exit traction.

How should I measure the effect of adding a 5g weight?

Record lap times and steering input before and after adding a 5g weight, and observe changes in mid corner balance and initial turn-in response under consistent battery and surface conditions.

Where are common mounting points for these weights?

Typical locations include the nose area to increase front bite, the rear pod for improved traction, or along the chassis rails to tune lateral balance. Ensure no interference with electronics or moving components.

Do they require specific adhesives for race use?

For short term testing, high tack double sided tape is effective. For longer deployments, use a thin film structural adhesive compatible with the chassis material to prevent movement under high G loads.

Can these weights be used in combination with other tuning parts?

Yes, they complement springs, sway bars and shock tuning. Treat weight changes as part of a holistic setup; small mass shifts can require spring or camber adjustments to maintain optimal balance.