3Racing 3RAC-NF40/TI Racing 4mm Titanium Flanged Lock Nuts 10pcs  [3RAC-NF40/TI]

3RACING 4mm Aluminum Flanged Lock Nuts (10 Pcs) - Titanium - 3RAC-NF40/TI
Price:
USD$4.30
Brand:
3Racing
Model:
3RAC-NF40/TI
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Performance-Focused 4mm Lock Nuts from 3Racing

The 3Racing 3RAC-NF40/TI 4mm Titanium Flanged Lock Nuts are specified for racers who prioritise dependable retention in critical areas. Produced from aluminium with a titanium finish, these lock nuts provide a balance of secure clamping and reduced mass compared to heavier steel equivalents. Use them where firm, repeatable fastening is required during tuning and setup changes.

Engineered Flange for Even Load Distribution

The integrated flange increases bearing area to distribute clamp loads over a larger surface, reducing point stress on mounts and brackets. This design consideration helps maintain consistent joint behaviour across repeated races and adjustments.

Practical for Setup Work and Pit Spares

Available in a 10 piece pack, these 4mm lock nuts are a practical addition to a race tool kit for component swaps and on-track repair tasks. Their common 4mm sizing makes them suitable for many chassis and accessory fixings used in competition cars.

Where in a race car would you typically fit these nuts?

Common uses include securing body mounts, accessory brackets and other 4mm fastened points that see regular maintenance or setup changes.

Are these suitable as direct replacements for stock fasteners?

They replace many standard 4mm nuts, but confirm thread pitch and clearance on the target component before use in competition-critical areas.

Any setup tips when fitting these lock nuts?

Tighten to a consistent torque and inspect mating surfaces for damage; the flange helps protect thin parts but correct torque ensures reliable retention during tuning and running.