3RACING 3RAC-WF305/BK Technical M3 0.5mm Aluminium Washer Pack 10  [3RAC-WF305/BK]

3RACING Aluminium M3 Flat Washer 0.5mm (10 Pcs) - Black - 3RAC-WF305/BK
Price:
USD$2.80
Brand:
3Racing
Model:
3RAC-WF305/BK
Condition:
Brand New
Write a review

Shim Control for Competitive Setup

For racers and experienced tuners, the 3RACING 3RAC-WF305/BK M3 flat washer 0.5mm offers consistent shim height for predictable setup adjustments. These washers provide repeatable spacing that helps preserve alignment when refining handling and drivetrain geometry.

Material Behavior and Handling

Manufactured from aluminium, these washers combine low mass with stable thickness. Use them where tight tolerances matter and check seating and torque to avoid compressive deformation in softer interfaces.

Application Notes for Tuning

Typical uses include fine shimming of suspension pivot points, motor mount spacing, and correcting minor steering linkage offsets. Stack in measured increments to document setup changes and return to baseline quickly during testing.

How should I document shim changes during testing?

Record the number of 0.5mm washers at each location and note handling differences. Incremental changes make it easier to correlate setup to on-track behaviour.

Is there a recommended fastening practice with thin aluminium shims?

Apply fasteners to recommended torque settings and verify washer flatness under load. Avoid excessive torque that could flare or thin the shim and alter the effective thickness.

Can these washers help with repeatable corner weight or geometry checks?

Yes. Using uniform 0.5mm shims lets you make measurable adjustments to ride height and pivot geometry, aiding consistent setup procedures during corner weight and alignment checks.