3RACING 3RAC-WF305/TI Titanium 0.5mm M3 Flat Washer Set (10 Pcs)  [3RAC-WF305/TI]

3RACING Aluminium M3 Flat Washer 0.5mm (10 Pcs) - Titanium - 3RAC-WF305/TI
Price:
USD$2.80
Brand:
3Racing
Model:
3RAC-WF305/TI
Condition:
Brand New
Write a review

Technical Note on 3RACING Aluminium M3 Flat Washers

These 3RACING M3 flat washers are manufactured as thin 0.5mm spacers with an aluminium base and a titanium finish, offering a lightweight solution for fine mechanical adjustments. They are intended for precision shimming where controlled clearance and repeatability are required.

Application Guidance for Competitive Setups

Use the 0.5mm washers to adjust bearing preloads, trim servo horn endplay, or fine tune suspension geometry. Their consistent thickness helps maintain setup repeatability across rebuilds and track sessions.

Material and Durability Considerations

The titanium finish improves surface wear characteristics and corrosion resistance while keeping mass low, which is critical in high frequency vibration environments and when minimising overall vehicle weight.

What tolerances should I expect from these washers?

Expect consistent 0.5mm thickness within normal manufacturing tolerances; inspect critical stacks and measure if absolute precision is required for high level setups.

Are these suitable for repeated disassembly in race environments?

Yes, the finish increases surface hardness and resistance to fretting, making them appropriate for parts that see frequent removal and reinstallation.

Any recommended installation practices?

Ensure washers are seated flat and avoid stacking more than necessary; verify torque values on thin shims to prevent distortion and check fit after initial run-in.