3RACING 4.8MM Ball Stud L=6 (10pcs) - 3RAC-BS4806/TI Racing Tuning Pack  [3RAC-BS4806/TI]

3RACING 4.8MM Ball Stud L=6 ( 10pcs) - 3RAC-BS4806/TI
Price:
USD$3.80
Brand:
3Racing
Model:
3RAC-BS4806/TI
Condition:
Brand New
Write a review

Precision Ball Studs for Tuning and Setup

The 3RACING 4.8MM Ball Stud L=6 (10pcs) - 3RAC-BS4806/TI supplies consistent ball geometry needed when refining suspension settings. Ten identical studs let racers replace multiple contact points to eliminate variability in repeated test runs.

Application in Competitive Setups

These studs are intended for use in steering links, camber links and other critical pivot points where predictable articulation is required. The 4.8mm dimension is common across many race platforms, enabling fast swaps without altering baseline geometry.

Serviceability and Fit Consistency

From a 3RACING parts perspective, consistent sizing reduces setup time and improves reproducibility of adjustments. Keep sets on hand for rapid trackside repairs to restore original link lengths and pivot behaviour with minimal downtime.

How do these studs affect repeatability of setup changes?

Using matched studs removes a variable from setup changes, so measurements such as toe and camber remain consistent after part replacement.

Should I replace all studs at once for a baseline rebuild?

For a true baseline, replacing multiple studs at once ensures uniform wear and geometry, which is beneficial when logging setup changes during test sessions.

What spares strategy is recommended for race day?

Carry at least one full 10 piece set for quick recovery from common link failures; this allows you to swap out several pivot points without searching for individual replacements.