3Racing 3RAC-BS58H5/TI 5.8mm Titanium Hex Ball Studs Racing Spec  [3RAC-BS58H5/TI]

3RACING 5.8MM Hex Ball Stud L=5 (10 pcs) - Titanium - 3RAC-BS58H5/TI
Price:
USD$3.70
Brand:
3Racing
Model:
3RAC-BS58H5/TI
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Racing-Oriented Titanium Ball Stud Upgrade

The 3Racing 5.8mm Hex Ball Studs are specified for racers seeking durable, low-mass suspension hardware. Manufactured to maintain consistent ball engagement and repeatable geometry, these studs are intended as a tuning-grade replacement for standard fittings.

Technical Advantages for Setup

From a setup perspective, titanium studs reduce unsprung mass while retaining high load capability, which helps when dialling in suspension balance and responsiveness. They are a useful part when refining steering feedback or cornering consistency.

Application and Tuning Notes

These 5.8mm hex ball studs suit a range of 1/10 scale race and club cars. When integrating them into a tuned setup, check ball cup wear and thread engagement to preserve repeatable geometry and minimise slop during sustained running.

What should I check when fitting these into a race car?

Confirm correct hex engagement, inspect mating ball cups for wear, and verify thread seating. Proper initial checks prevent early geometry changes during running.

Do these studs affect suspension tuning points?

They can influence unsprung mass and micro-level compliance at the ball joint, so recheck ride height and camber after installation as part of a full setup pass.

Any fitment advice for competitive use?

Use precise drivers, avoid over-tightening, and perform a short break-in with periodic inspections to ensure stable performance across practice and race sessions.