3RACING 64 Pitch 29T Pinion Gear Technical Edition - 3RAC-PG6429  [3RAC-PG6429]

3RACING 64 Pitch Pinion Gear 29T (7075 w/ Hard Coating) - 3RAC-PG6429
Price:
USD$3.80
Brand:
3Racing
Model:
3RAC-PG6429
Condition:
Brand New
Write a review

Technical Brief: 29T 64 Pitch Pinion for Tuned Drivetrains

The 3RACING 64 Pitch Pinion Gear 29T utilises 7075 aluminum with a hard coating to deliver a robust gear interface for performance-oriented builds. The design focuses on repeatable mesh and reduced abrasive wear in demanding conditions.

Material Performance and Service Life

7075 aluminium provides a strong substrate for gear teeth, while the hard coating reduces surface degradation. Together these attributes support extended service life and consistent tooth geometry under continuous load.

Installation and Tuning Notes

Intended for 64 pitch systems, the 29T is compatible with standard spurs. For optimal results, set motor position for minimal backlash and verify run-in mesh under low torque before full power tuning sessions.

Maintenance and Replacement Strategy

Inspect tooth faces after heavy runs and monitor mesh wear. The hard coat delays surface wear but scheduled checks and replacing worn components remains best practice for race preparation.

What gear mesh clearance is recommended?

Aim for a tight but smooth mesh with a small amount of play to avoid binding. Confirm contact across several teeth and fine tune for your motor and spur combination.

Should I run in the pinion before a race day?

Yes. Perform low load break-in runs to seat the coating and confirm stable engagement before high stress sessions or competitive events.

Any advice for pairing with aftermarket spurs?

Match pitch and tooth count, then set mesh and run test laps to check for consistent wear across the interface. Balanced setups preserve spur and pinion life.