3RACING 3RAC-SG64114/V3 64 Pitch 114T Spur Gear - Racing Setup  [3RAC-SG64114/V3]

Price:
USD$4.40
Brand:
3Racing
Model:
3RAC-SG64114/V3
Condition:
Brand New
Write a review

Race-oriented analysis of the 3RACING 3RAC-SG64114/V3 spur gear

The 3RACING 3RAC-SG64114/V3 is engineered for competitive users who require predictable gear engagement and fine ratio resolution. Its 114 tooth 64 pitch geometry assists in precise tuning of effective gear ratios and drivetrain behaviour under load.

Design and tuning advantages

Using a 64 pitch spur with 114 teeth allows smaller incremental changes to final drive ratios, which is valuable for on-track lap time optimisation. The gear's profile aims to balance tooth strength with acceptable rotational inertia for race setups.

Installation protocol and service notes

Install the 3RACING 3RAC-SG64114/V3 with a correctly specified 64 pitch pinion and set backlash to the minimum safe clearance for your application. Monitor mesh patterns on the gear faces after initial running and inspect for progressive wear; correct lubrication and shaft support reduce distortion and maintain repeatable timing.

What mesh pattern should I aim for with this spur?

Aim for an even contact patch across the tooth face with minimal end float; this indicates correct mesh and prolongs tooth life while minimising noise and power loss.

How does 114T affect tuning granularity?

A higher tooth count like 114T provides finer steps between pinion choices, allowing more nuanced ratio adjustments without drastic changes to motor load.

Any recommendations for endurance events?

For long runs, ensure robust lubrication, check bearing play that could affect alignment, and periodically inspect teeth for early wear signs to prevent failure during competition.