3RACING 64 Titanium 3mm Turnbuckle Set - 42mm (2 Pcs) - 3RAC-TR342 Racing Setup Linkage  [3RAC-TR342]

3RACING 64 Titanium 3mm Turnbuckle - 42mm (2 Pcs) - 3RAC-TR342
Price:
USD$4.40
Brand:
3Racing
Model:
3RAC-TR342
Condition:
Brand New
Write a review

Performance Turnbuckles from 3RACING 64

The 3RACING 64 Titanium 3mm Turnbuckle - 42mm is targeted at tuners seeking dependable, lightweight linkage hardware for close setup work. Built to withstand frequent adjustments, these turnbuckles support repeatable steering geometry changes without significant wear.

Installation and Setup Notes

Use correct rod ends and a turnbuckle tool to avoid damaging the surface finish. Ensure threads are clean and engage fully; confirm neutral steering position before locking in final adjustments to maintain symmetric handling.

Tuning Benefits for Competitive Use

By replacing heavier steel parts with titanium, you lower unsprung or rotating mass at the linkage points, which can sharpen steering feedback and help maintain alignment under load. Their corrosion resistance also reduces variability in performance across track conditions.

What are best practices for thread engagement?

Ensure at least several full turns of engagement on each end, avoid cross-threading, and back off before final clamping to verify geometry alignment.

How should I protect the finish during adjustments?

Use dedicated soft-jaw pliers or a proper turnbuckle wrench to prevent marring; avoid excessive force which can damage threads and affect adjustability.

Are these recommended for aggressive race setups?

They are suited to tuning-focused setups where repeated adjustments are expected; inspect components regularly and replace any that show thread fatigue after intensive use.