3RACING Aluminum Body Post 7075 Teflon Coated 4.3MM Hex Ball Stud L=7.7 M2.6 (5pcs) - 3RAC-BS43077/TE Racing Spec  [3RAC-BS43077/TE]

3RACING Aluminum Body Post 7075 4.3MM Hex Ball Stud L=7.7 M2.6 (5pcs) - Teflon Coated - 3RAC-BS43077/TE
Price:
USD$5.70
Brand:
3Racing
Model:
3RAC-BS43077/TE
Condition:
Brand New
Write a review

Track oriented 7075 aluminium body studs

The 3RACING Aluminum Body Post 7075 Hex Ball Studs are produced with racing maintenance in mind, offering a high strength to weight ratio from 7075 aluminium that helps keep unsprung mass low while improving longevity of mounting points.

Performance surface treatment

The Teflon coating reduces static and dynamic friction at the interface, improving consistency of body retention and reducing play at pivot points. This treatment is useful during repeated pit work and fast body swaps between runs.

Dimensional data and install notes

These studs use a 4.3mm hex engagement, 7.7mm overall length, and M2.6 thread. For competitive use verify thread compatibility and consider torque settings that prevent overloading threads while maintaining secure clamping force.

What torque should I use when fitting these studs?

Use light controlled torque appropriate to M2.6 fasteners and the material you are threading into. Over torque can strip small threads, so tighten to secure fit without excessive force.

Can these studs be used with quick release body posts?

Yes, the low friction surface helps with quick release action. Verify clearances and mounting depth so the release mechanism operates without binding.

Any tuning advice for repeatable body alignment?

Match stud height and use shims or washers to fine tune body position. Consistent torque and clean mating surfaces will yield repeatable alignment between runs.