3RACING Aluminum Center Pulley Gear T16 Racing Spec - 3RAC-3PY/16  [3RAC-3PY/16]

3RACING Aluminum Center Pulley Gear T16 - 3RAC-3PY/16
Price:
USD$7.60
Brand:
3Racing
Model:
3RAC-3PY/16
Condition:
Brand New
Write a review

Racing-Focused Centre Pulley for Consistent Drive

The 3RACING Aluminum Center Pulley Gear T16 is intended as a value-conscious upgrade for tuners who need dependable centre gear performance. Its metal construction reduces deformation under load and helps preserve gear geometry during repeated high-load cycles.

Application Notes for Tuners

Ideal for racing or high-use club running where component wear affects lap times. The pulley integrates with common drivetrain layouts and supports repeatable mesh and torque transmission when installed with correct alignment and bearing condition.

Setup and Maintenance for Performance

During installation, confirm shaft concentricity and clearance to adjacent parts to avoid lateral loading. Schedule routine inspections and service bearings and collars to maintain optimal drivetrain efficiency and extend service intervals.

How should I verify fitment before track use?

Check shaft diameter, keying or set screw engagement and ensure no axial play. Spin the drivetrain by hand to confirm smooth rotation before running.

What tuning changes should I expect after upgrading?

Expect steadier gear mesh with reduced plastic deformation; this can slightly affect backlash tuning, so recheck mesh and idle behaviour after fitting.

Any recommended complementary upgrades?

Inspect and, if needed, upgrade bearings and shafts to match the pulley durability; a solid bearing setup supports consistent performance.