3RACING Aluminum Center Pulley Gear T23 3RAC-3PY/23 - Racing Setup Part  [3RAC-3PY/23]

3RACING Aluminum Center Pulley Gear T23 - 3RAC-3PY/23
Price:
USD$7.60
Brand:
3Racing
Model:
3RAC-3PY/23
Condition:
Brand New
Write a review

Race Setup Focused 3Racing 3RAC-3PY/23 Centre Pulley

The 3Racing Aluminum Center Pulley Gear T23, model 3RAC-3PY/23, is intended for tuners focused on consistent torque distribution and predictable drivetrain behaviour. Its aluminium construction helps reduce rotating mass which assists in sharper throttle transitions during competitive runs.

Tuning Advantages for Competitive Use

As a lightweight component the pulley supports quicker acceleration steps and repeatable control inputs. It integrates into a race setup where fine marginal gains to drivetrain efficiency and balance contribute to lap time consistency.

Compatibility and Use Cases

Suitable for a broad set of RC configurations that require exacting power transfer, the pulley is a straightforward performance upgrade for racers and advanced hobbyists seeking improved drivetrain response and handling stability.

What should I check for alignment when installing?

Ensure shaft concentricity and check that the pulley runs true with the mating gear or belt line to avoid vibration and premature wear.

Can this pulley handle higher torque setups?

It is suitable for tuned hobby and club race applications; verify that surrounding drivetrain components are rated for the increased loads to prevent weak link failures.

What adjustments improve drivetrain consistency?

Use properly torqued fastenings, matched bearings and careful alignment. Small trims to gear mesh and shaft support can yield noticeable gains in repeatable performance.