3RACING Auper D6 Aluminum Rear Upper Arm Bolt SAK-D6823A - Racing Spec  [SAK-D6823A]

Price:
USD$5.00
Brand:
3Racing
Model:
SAK-D6823A
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Racing focused aluminium rear upper arm bolt for Auper D6

The 3RACING SAK-D6823A rear upper arm bolt is produced to provide a precise, repeatable mount point for Auper D6 rear suspension. It is intended to keep alignment and articulation consistent under competitive running conditions.

Material and application notes for tuners

Aluminium delivers a favourable strength to weight ratio for suspension fasteners where reducing unsprung mass is desirable. When planning a setup change, factor in the bolt material relative to your chosen arm design and pivot tolerances to preserve predictable handling.

Installation and workshop checks

Fit the bolt using the correct torque sequence and inspect mating faces for burrs or deformation that could affect preload. Regular inspection after aggressive use will help you detect wear early and maintain consistent suspension geometry.

What should I check before fitting the bolt?

Verify hole alignment and clear any debris from pivot areas. Confirm that socket or wrench fits head correctly to avoid rounding during torque application.

Any setup changes recommended after swapping to aluminium?

After replacement, perform a quick handling check and verify toe and camber remain within your baseline. Small shifts in mass can alter trim settings at the limit.

How often should I inspect this component in race use?

Inspect bolts and pivot areas after each event or after any heavy impact. Look for thread wear, head damage, or any movement at the joint that indicates replacement is required.