3Racing 3RAC-BP128/RE Red Rear-End Ball End Stiffener - Racing Setup Part  [3RAC-BP128/RE]

3RACING Ball End Rear-End Stiffener - Red - 3RAC-BP128/RE
Price:
USD$4.40
Brand:
3Racing
Model:
3RAC-BP128/RE
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Racing focused rear stiffening from 3Racing

For competitive tuners focusing on chassis behaviour, the 3Racing Ball End Rear-End Stiffener in red provides a straightforward way to increase rear lateral rigidity. The 3Racing 3RAC-BP128/RE Red Rear-End Ball End Stiffener is suited to drivers who adjust stiffness targets to refine turn-in and mid corner balance.

Performance tuning notes

Fitting the 3Racing Ball End Rear-End Stiffener reduces unwanted rear flex, helping maintain predictable traction during cornering. Use this part as part of an iterative setup process, combining it with shock and antiroll bar adjustments to reach the desired handling balance.

Installation and setup workflow

Installation is simple using standard hobby tools, allowing rapid fitment between runs. After installation, assess handling over a measured sequence of laps and make incremental setup changes rather than large one-off adjustments.

Will this part integrate with common 1/10 competition chassis?

Yes, the stiffener is intended to work with a wide range of 1/10 competition platforms; confirm mounting points and clearances before final fitment.

How should I evaluate changes after fitting?

Use lap time comparison and consistent test sections to judge handling differences, and adjust damping or roll stiffness in small increments for precise results.

Is this part suitable for tight tuning programs?

Yes, it is a practical tuning component for competitive setups where small changes to chassis stiffness can yield predictable handling improvements.