3Racing CAC-153 Cactus 2WD 1mm EVA Sticker for Race Setup  [CAC-153]

3RACING Cactus 2WD 1MM EVA Sticker - CAC-153
Price:
USD$2.50
Brand:
3Racing
Model:
CAC-153
Condition:
Brand New
Write a review

Setup note: precision fitting for 3Racing CAC-153

This 1mm EVA sticker from 3Racing is intended as a precise under-chassis liner for the Cactus 2WD. It provides a thin, non-intrusive protective layer that helps guard the chassis base from abrasion while preserving component clearance. The adhesive backing allows quick placement so the chassis can be returned to service with minimal downtime.

Technical highlights for tuners

  • Material: 1mm EVA foam selected for consistent compression and abrasion resistance.
  • Compatibility: Profiled to match Cactus 2WD chassis geometry for repeatable fitment.
  • Functionality: Reduces direct wear on the chassis and provides a small amount of vibration damping.
  • Installation: Adhesive-backed sheet for accurate positioning during setup changes.

Should I use this during chassis setup changes?

Yes. The low profile helps protect the chassis during frequent handling and setup swaps without altering baseline geometry.

Any trimming advice for fine tuning fit?

Use a sharp hobby knife and trim incrementally. Test fit before final adhesion to maintain alignment with mounting points and wiring runs.

Will the pad influence corner feel or balance?

The material is very thin and light; any change to handling is negligible. It is intended for protection and cleanliness rather than tuning of dynamic behaviour.