3RACING Cero Rapid 1.0mm Lower Suspension Spacer SAK-C168C Race Setup  [SAK-C168C]

3RACING Cero Rapid 1.0mm Lower Suspension Spacer - SAK-C168C
Price:
USD$6.30
Brand:
3Racing
Model:
SAK-C168C
Condition:
Brand New
Write a review

3RACING Cero Rapid 1.0mm Lower Suspension Spacer Technical Notes

The 3RACING Cero Rapid 1.0mm Lower Suspension Spacer, model SAK-C168C, is a small but effective tuning component intended for racers focused on setup refinement. It provides a defined change to lower link position to influence roll behaviour and transient response.

Purpose and Performance Impact

In tuning terms, a 1.0mm spacer modifies the lower mount height enough to affect roll centre and leverage ratios. That change can be used to fine-tune understeer characteristics and improve consistency through a sequence of corners.

Compatibility Considerations

Best used on Cero Rapid platforms and compatible chassis with similar lower link geometry. Confirm mounting dimensions and suspension travel to ensure the spacer does not introduce binding or exceed recommended clearances.

Installation and Verification

Fit the spacer on a calibrated bench, torque fasteners to manufacturer recommendations, and validate full suspension articulation. Follow up with controlled track testing to record measurable changes before committing to further setup adjustments.

What is the expected change in roll centre from a 1.0mm spacer?

A 1.0mm shift produces a small roll centre adjustment; the exact value depends on link geometry. Use it for incremental tuning rather than large geometry revisions.

How should lap testing be structured after fitting?

Run baseline laps, fit the spacer, then repeat identical test runs to compare lap times and handling notes. Change only one variable at a time for clear data.

Are there recommended complementary setup changes?

Depending on results, minor camber or anti-roll bar adjustments can complement the spacer. Aim for small increments and document each change for reliable tuning decisions.