3RACING Cero SAK-C149 Rear Upper Wishbone - Race Replacement  [SAK-C149]

Price:
USD$5.00
Brand:
3Racing
Model:
SAK-C149
Condition:
Brand New
Write a review

Race oriented rear upper wishbone for the 3RACING Cero

The 3RACING Cero Rear Upper Wishbone (SAK-C149) is engineered as a direct replacement to preserve the rear suspension kinematics of the Cero chassis. It maintains intended roll center and toe response under race conditions.

Setup focused design notes

Fitted to standard mounting points, the SAK-C149 offers predictable articulation for tuning dampers and anti-roll bias. Accurate geometry is important for lap time consistency, and this wishbone supports repeatable results.

Installation and compatibility considerations

Purpose built for the 3RACING Cero series, the SAK-C149 installs without modification. For optimal performance check hinge pin wear, bushing clearance and ensure correct torque on mounting hardware during installation.

What should I inspect when fitting the SAK-C149?

Inspect hinge pins for endplay, verify bushing condition and confirm wheel hub alignment. Any slop at these points will compromise setup accuracy.

Does replacing the wishbone change baseline handling?

Replacing a worn arm returns geometry to design spec; you may need to recheck toe and camber to restore your baseline setup for consistent handling.

Any setup tips after installation?

After fitting, perform a static alignment check and run a few low speed laps to confirm roll response before making further damper or anti-roll bar adjustments.