3RACING SAK-CS102 Front Solid Axle for Cero Sport Race Setup  [SAK-CS102]

3RACING Cero Sport Front Solid Axle For Cero Sport - SAK-CS102
Price:
USD$7.60
Brand:
3Racing
Model:
SAK-CS102
Condition:
Brand New
Write a review

Race-oriented front axle for controlled handling

The 3RACING Front Solid Axle SAK-CS102 is designed for drivers seeking predictable front-end dynamics. By replacing the front differential, the axle enforces matched rotation at both front wheels, helping to stabilise understeer tendencies and create a more consistent contact patch during cornering.

Tuning advantages for competitive setups

Using the solid axle simplifies front behaviour, allowing more precise adjustments to front toe and steering geometry. This makes setup changes more repeatable between runs and helps teams converge on an optimal balance for sealed circuits.

Installation and setup guidance

The SAK-CS102 installs into the Cero Sport chassis with standard toolsets and uses the stock mounting points. After fitting, make incremental steering and toe adjustments during test laps to fine tune turn-in and mid-corner balance.

How should I adjust toe after fitting the axle?

Start with the stock toe settings and reduce toe-out in small increments while evaluating turn-in precision; many racers find small toe adjustments yield better front bite.

Does the axle change roll behaviour that affects anti-roll bar selection?

Yes. With a solid front axle, roll characteristics shift, so you may need to revisit front anti-roll bar stiffness to maintain desired roll balance with the rear.

What should I monitor after switching to the solid axle?

Monitor steering response, tyre wear, and lap time consistency over multiple runs. Make small incremental setup changes rather than large ones to isolate effects.