3Racing SAK-C148C/V2 Cero Ultra 2.0 Race Setup Rear Swing Shaft Housing  [SAK-C148C/V2]

3RACING Cero Ultra 2.0 Rear Swing Shaft Axle Housing - SAK-C148C/V2
Price:
USD$3.70
Brand:
3Racing
Model:
SAK-C148C/V2
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Race-Tuned Rear Axle Housing for Cero Ultra 2.0

The 3Racing SAK-C148C/V2 rear swing shaft axle housing is developed with competitive setups in mind, delivering a firmer rear end connection on the Cero Ultra 2.0 chassis. The design focuses on repeatable geometry to support consistent handling during tuning sessions.

Setup and Performance Focus

Built to complement performance tuning, this housing helps maintain drivetrain alignment under load and supports predictable responses to suspension and toe adjustments. Its fit promotes reliable behaviour when iterating setup changes.

Installation and Tuning Advice

As a direct-fit component for the Cero Ultra 2.0, the SAK-C148C/V2 integrates with standard mounting points to reduce installation time. After fitting, verify alignment and perform a few setup runs to dial in toe and suspension settings for best lap consistency.

What setup changes pair well with this housing?

Drivers often use this housing alongside minor toe and camber adjustments to fine tune rear traction. It helps maintain geometry so suspension tuning has predictable effects.

Any recommended post-install checks?

Check driveline rotation for binding, confirm fastener torque, and run a short test sequence to confirm handling responses before full race setup.

Is this suitable for competitive class racing?

Yes, the SAK-C148C/V2 is intended for drivers who need consistent parts for tuning and racing; it supports iterative setup work without introducing variability from the rear mounting points.