3Racing CRA-133 30T Spiral Gear for Crawler Ex Real Racing Spec  [CRA-133]

3RACING Crawler Ex Real 30T x 0.9mm Spiral Gear - CRA-133
Price:
USD$5.60
Brand:
3Racing
Model:
CRA-133
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Racing grade spiral gear solution from 3Racing for tuned crawlers

The 3Racing CRA-133 is a 30T x 0.9mm spiral gear developed for the Crawler Ex Real series with a focus on precise engagement and repeatable drivetrain response. It supports controlled torque transfer under load and is suitable for competitive crawling setups that demand consistent component behaviour.

Technical advantages for performance builds

Produced to close tolerances, the CRA-133 targets improved drivetrain characteristics:

  • Durability: Engineered to withstand repeated high torque cycles typical in performance crawling environments.
  • Precision Engineering: The 30 tooth, 0.9mm profile ensures uniform contact pattern and predictable backlash control.
  • Seamless Compatibility: Direct fit for Crawler Ex Real transmissions to maintain factory geometry and tuning presets.

Is the CRA-133 suitable for high torque motors?

Yes, the CRA-133 is designed to cope with increased torque loads when used within the recommended drivetrain and motor limits for Crawler Ex Real platforms.

What tuning steps optimise mesh and longevity?

Set minimal but consistent backlash, use a suitable high pressure gear lubricant, and verify alignment under static and dynamic conditions to optimise life span.

Are there recommended break-in practices for race use?

Perform controlled low load runs to seat the teeth, then inspect contact pattern and fastener torque before competitive use.