3Racing CRA-129 Competition 6.8mm Pillow Ball  [CRA-129]

3RACING Crawler Ex Real 6.8mm Pillow Ball - CRA-129
Price:
USD$5.00
Brand:
3Racing
Model:
CRA-129
Condition:
Brand New
Write a review

Competitive Grade Pillow Ball for Crawler Ex Real

The 3Racing CRA-129 6.8mm pillow ball is specified for competitors and tuners refining suspension behaviour on Crawler Ex Real platforms. It provides a stable pivot interface that assists precise geometry adjustments and repeatable handling characteristics under varied load conditions. The design supports predictable articulation and straightforward integration with factory mounting points.

How does the CRA-129 influence tuning range?

By reducing joint lash, the pillow ball sharpens suspension feedback, enabling finer adjustments to link geometry and a more consistent response during timed runs.

Any setup recommendations for competition use?

Check articulation through full travel after fitting, confirm alignment under load, and pair with matched link lengths to exploit the tighter joint behaviour for improved line holding.

Maintenance guidance for repeated events?

Inspect for wear between events, keep contact areas clean from grit, and verify fastener torque before each run to maintain consistent performance.