3RACING CRA-106 Crawler Ex Real Gearbox Plate Performance Part  [CRA-106]

3RACING Crawler Ex Real Gear Box Plate - CRA-106
Price:
USD$5.00
Brand:
3Racing
Model:
CRA-106
Condition:
Brand New
Write a review

Technical notes on the 3RACING CRA-106 gearbox plate

The 3RACING Crawler Ex Real Gear Box Plate (CRA-106) is engineered to maintain gearbox alignment and reduce lateral movement under load. It is intended for direct integration into Crawler Ex Real chassis layouts to preserve gear mesh consistency and drivetrain efficiency.

Installation and setup considerations

Install the CRA-106 using standard RC tooling and verify fastener torque to manufacturer values. After fitting, check gear mesh and drivetrain backlash; the plate stabilises gearbox position which can reduce the need for frequent mesh readjustments under competitive conditions.

Tuning and upgrade compatibility

When used with common tuning parts and lightweight performance upgrades, the CRA-106 helps maintain a stable reference point for the gearbox. Confirm that any aftermarket components do not modify gearbox mounting offsets, and re-check alignment after changes to motor or transmission components.

What setup checks should I perform after fitting the CRA-106?

Verify fastener torque, confirm gearbox alignment and inspect gear mesh under static conditions. Perform a short run to confirm there is no abnormal noise or binding before competitive use.

Is the plate compatible with tuning modifications that alter gearbox height?

If a modification changes gearbox height or lateral position, check mounting patterns and offsets. The CRA-106 is optimised for stock Crawler Ex Real geometry and may require additional shimming or adapters for altered layouts.

Can this plate reduce the frequency of mesh adjustments during tuning cycles?

By locking the gearbox into a consistent position, the plate can lessen the rate of mesh drift caused by chassis flex and minor impacts, lowering the number of fine mesh tweaks needed during setup iterations.