3RACING 3RB-MR62-ZZ/2 Double Metal Shield Bearings 2x6x2.5mm (2 pcs) - Race Setup Grade  [3RB-MR62-ZZ/2]

3RACING Double Metal Shield Bearing 2 x 6 x 2.5 mm (2 pcs) - 3RB-MR62-ZZ/2
Price:
USD$1.80
Brand:
3Racing
Model:
3RB-MR62-ZZ/2
Condition:
Brand New
Write a review

Race Setup Grade 3RACING Shielded Bearings

Engineered for competitive hobbyists, the 3RACING double metal shield bearings in 2x6x2.5mm offer consistent low friction and protection against particulate ingress. This two piece set supports predictable rotational response under load and helps preserve drivetrain geometry during extended running.

Design Advantages for Tuning

Double-sided metal shields reduce contamination risk while keeping bearing drag minimal, which matters when fine tuning handling and acceleration. Using quality shielded bearings lowers the chance of mid-run degradation that can affect lap times.

Typical Fitment and Notes

These bearings suit wheel hubs, gearbox shafts and small motor interfaces where compact, repeatable fit is required. For best results in performance setups, fit bearings using tools that load the outer race only and verify shaft runout after installation.

What lubrication approach is recommended for race use?

Use a light, high-speed bearing oil for minimal drag, topped with a thin film of synthetic grease if extra protection is needed for longer events.

Any fitting tips to avoid bearing damage?

Press bearings in using a driver that contacts the outer race, avoid hammering the inner race and check alignment to prevent preloading under load.

How do these compare for durability versus sealed hybrid bearings?

Metal shielded bearings balance protection and speed; hybrid sealed bearings can offer better sealing but may add more drag depending on seal design, so choose based on your priorities.