3Racing F113-110/WO Front Shock Tower Racing Setup Part  [F113-110/WO]

3RACING F113 Front Shock Tower - F113-110/WO
Price:
USD$7.60
Brand:
3Racing
Model:
F113-110/WO
Condition:
Brand New
Write a review

Technical Front Tower for F113 Chassis Tuning

The 3Racing F113-110/WO front shock tower provides a stiff, predictable mounting point for front suspension components on the F113 chassis. It reduces unwanted flex to maintain consistent camber and toe under load, aiding repeatable setup changes.

Precision Carbon Construction

Fabricated from quality carbon, this tower balances low mass with high rigidity to support competitive tuning moves. The reduced compliance across the front end helps translate suspension adjustments into reliable on-track behaviour.

Optimised for Competitive Adjustments

Engineers and racers will appreciate the clear mounting references that make it easier to swap settings and compare results. The 3Racing F113-110/WO accepts the common shock placements used in competitive F113 setups.

Straightforward Upgrade Path

The component is intended as a direct front tower replacement that simplifies the upgrade process for racers wanting immediately usable gains in steering precision and setup consistency.

How does increased tower stiffness affect setup tuning?

Higher stiffness reduces chassis-induced geometry changes, so adjustments to camber, toe and damper settings produce more predictable results. Expect to retune for your preferred balance after fitting.

Is this tower compatible with progressive shock positions?

The tower supports the standard shock mount locations on the F113. If you use nonstandard leverages or extended rods, verify travel and clearance before finalising the build.

What should I check after installation?

After fitting the 3Racing F113-110/WO, confirm alignment, shock lengths and spring preload. Run a few measured laps and adjust damping to account for the tower's increased rigidity.