3Racing SAK-D6821F Sakura D6 Dual Joint Pin Technical Spare  [SAK-D6821F]

3RACING KIT-SAKURA D6 Dual Joint Pin M1.5 x 7.8 - SAK-D6821F
Price:
USD$1.30
Brand:
3Racing
Model:
SAK-D6821F
Condition:
Brand New
Write a review

Race-Level Dual Joint Pin for Sakura D6

The 3Racing SAK-D6821F Dual Joint Pin is engineered to meet the Sakura D6 linkage geometry, delivering consistent joint alignment and robust performance. With an M1.5 x 7.8mm dimension, the pin preserves steering kinematics and resists deformation under repeated load cycles. Its form and fit allow quick replacement during race service without compromising handling precision.

How critical is pin diameter to steering geometry?

Maintaining the specified M1.5 diameter is essential. Even slight undersize can introduce play and alter steering response. Always replace with correct-dimension spares like the SAK-D6821F.

Recommended inspection intervals for race use?

Inspect pins after any heavy impact and as part of routine pre-event checks. High-mileage or aggressive track conditions warrant more frequent inspection cycles.

What tolerances should I expect from replacement pins?

Quality replacement pins should hold close tolerances to the original spec. Verify seating and joint rotation after installation to confirm there is no binding or excessive clearance.