3Racing SAK-D651/BU Sakura D6 Sport Racing Gear Set  [SAK-D651/BU]

3RACING KIT-SAKURA D6 SPORT M1.2 x 14 x 34mm_9T (2 pcs)_Blue - SAK-D651/BU
Price:
USD$3.80
Brand:
3Racing
Model:
SAK-D651/BU
Condition:
Brand New
Write a review

Racing-Focused Blue 9T Gears for Sakura D6 Setup

The 3Racing Sakura D6 Sport Gear Set in blue is engineered for drivers refining drivetrain behaviour in 1/10 scale drift competition. Supplied as two gears at M1.2 x 14 x 34mm with a 9T tooth count, the set maintains accurate meshing to aid repeatable throttle response and predictable slip characteristics. Intended for the Sakura D6 chassis, these gears support tuning work and routine component refreshes without altering intended geometry.

How should I adjust gear mesh for competitive setups?

Set a close but free mesh, verify under load at low throttle, and use minimal shimming to prevent backlash while avoiding binding that could stress the 9T gears.

Are these gears recommended for tuning changes?

Yes, the consistent M1.2 x 14 x 34mm sizing and 9T specification make them suitable when adjusting final drive behaviour as part of a wider setup strategy.

What inspection points prevent premature wear?

Check pinion alignment, shaft runout and bearing condition regularly; correct assembly and clean installation extend service life of the 9T gear pair.