3Racing SAK-D622 Brass Spacer M5 x 7 x 11.5 for Sakura D6 Sport  [SAK-D622]

3RACING KIT-SAKURA D6 SPORT M5 x 7 x 11.5 Brass Spacer - SAK-D622
Price:
USD$2.50
Brand:
3Racing
Model:
SAK-D622
Condition:
Brand New
Write a review

Precision Spacer for Tuning Sakura D6 Sport Assemblies

The 3Racing SAK-D622 brass spacer is specified at M5 x 7 x 11.5 and manufactured to provide repeatable stack height and accurate alignment on the Sakura D6 Sport chassis. It is a compact component intended to stabilise fastened joints and support consistent setup adjustments.

Engineering Advantages for Racing Setups

Using brass delivers predictable thread engagement and local mass where needed, which can aid in fine tuning balance and component interaction. The SAK-D622 is suited to builders focused on reliable, serviceable parts in competitive environments.

Workshop Fitment Notes

  • Verify spacer dimensions against assembly drawings before final installation.
  • Ensure correct thread start and torque sequencing to protect mating threads during repeated service intervals.
  • Include the spacer in setup checks after any suspension or chassis geometry changes to maintain repeatability.

How does spacer length affect stack height tuning?

Spacer length directly changes local stack height at the fastening point; using the specified 11.5 mm length ensures intended component spacing and alignment in the Sakura D6 Sport geometry.

Are there specific torque recommendations for brass spacers?

Torque should secure the joint without crushing the spacer or damaging threads. Follow chassis or fastener guidance and re-check after initial runs to confirm retention.

What inspection routines are advised for spacers?

Regularly inspect contact faces and thread engagement for signs of fretting or wear. Replace parts showing deformation to preserve setup accuracy and safety.