3RACING Race Grade M5.8 x 7.5mm Ball Stud 3mm Hole - 3RAC-BS5875  [3RAC-BS5875]

3RACING M5.8 x 7.5mm Ball Stud 3mm Hole - 3RAC-BS5875
Price:
USD$6.30
Brand:
3Racing
Model:
3RAC-BS5875
Condition:
Brand New
Write a review

Race-Oriented Ball Studs for Tuned Linkage Control

The 3Racing M5.8 x 7.5mm Ball Stud with a 3mm hole is intended to provide predictable pivot points for suspension linkages in performance-focused setups. It aids in preserving intended geometry under load so handling trim remains consistent during tuning sessions.

Setup and Tuning Applications

Suitable for racers and serious tuners, these studs offer a dependable interface between arms and linkages. They help maintain repeatable responses when adjusting roll centres, ackermann or camber links without introducing unwanted slop.

Installation and Maintenance Recommendations

Install the 3Racing studs with consistent torque and verify joint free play during static checks. For track use, routinely inspect the joints for wear and confirm secure seating after setup changes to preserve handling predictability.

Which setups benefit most from these studs?

They are most effective on precision setups where small changes to geometry affect lap times, for example tuned touring and pan car rigs that require tight pivot control.

How should I verify fit during setup?

Check that the ball seats without lateral movement and that linkage range is unimpaired. Use static checks and short runs to confirm no binding occurs under steering or suspension travel.

Are these suitable for progressive tuning changes?

Yes, they support iterative tuning since they keep pivot points stable as you alter settings; consistent inspections between adjustments will maintain repeatability.