3Racing SAK-A538/GR Racing Grade Chassis Spacers  [SAK-A538/GR]

3Racing Sakura M4 M1.4 x 14 x 20.5_5.25T C2.80 (2 pcs)_Green - SAK-A538/GR
Price:
USD$3.80
Brand:
3Racing
Model:
SAK-A538/GR
Condition:
Brand New
Write a review

Technical Upgrade for Sakura M4 Geometry

The 3Racing Sakura M4 Chassis Spacer Set in green consists of two accurately finished spacers intended to refine mounting points and reduce lateral compliance. These components support predictable responses when adjusting camber, toe, and suspension pivots.

Technical Notes

  • Material: Aluminium construction chosen for stiffness to weight efficiency.
  • Anodized Finish: Hard anodizing increases wear resistance and preserves dimensional stability.
  • Compatibility: Machined to match Sakura M4 mounting interfaces for repeatable registration.
  • Dimensions: M1.4 x 14 x 20.5_5.25T C2.80 for accurate placement within factory tolerances.

What tolerance control should I expect from these spacers?

They are produced to tight dimensional tolerances to minimise slop at mounting points, which helps maintain consistent suspension geometry under load.

Do these require special installation tools?

Standard precision hand tools suffice; use a calibrated torque driver and thread prep where specified to avoid over-stressing fasteners.

Will the spacers alter baseline setup measurements?

They are intended to stabilise baseline geometry rather than change ride height. Re-measure alignment after fitting to confirm setup remains within target values.

Are these suitable for competitive tuning and frequent disassembly?

Yes. The anodized aluminium construction stands up to repeated assembly cycles, but inspect mating surfaces for wear when servicing between events.