3Racing SAK-A548 Racing Graphite Front Shock Tower for Sakura Advance 20M  [SAK-A548]

3RACING Sakura Advance 20M Front Graphite Shock Tower - SAK-A548
Price:
USD$10.00
Brand:
3Racing
Model:
SAK-A548
Condition:
Brand New
Write a review

Race-Oriented Shock Tower for Sakura Advance 20M

The 3Racing SAK-A548 front shock tower is manufactured to support competitive setup work on the Sakura Advance 20M. Using graphite keeps mass down while increasing the rigidity of the shock top, which helps maintain repeatable geometry across runs. The part is dimensioned for consistent mounting and predictable behaviour under lap-to-lap load cycles.

Setup Benefits for Tuners

Fitting the SAK-A548 reduces compliance at the shock mounts, sharpening steering response and improving the driver feedback loop. Tuners will find that changes to damper valving and spring rates translate more directly into chassis behaviour with the stiffer top mount.

Installation and Practical Notes

Install the tower with standard workshop tools and ensure all fasteners are torqued to a consistent setting. After mounting, verify camber, toe and ride height to confirm the new tower has not altered alignment, then fine tune damping to suit the stiffer front end.

How does the SAK-A548 affect setup sensitivity?

The increased stiffness makes the front end more sensitive to damping and spring changes, so small setup tweaks produce clearer handling differences.

Are there recommended damper settings when using this tower?

No universal setting fits all tracks; start with slightly softer damping and fine tune towards firmer settings until the desired balance and front bite are achieved.

Does graphite require different maintenance than plastic towers?

Inspect mounting holes and edges after impacts for any cracks; while durable under load, graphite will show different wear patterns and should be replaced if structural damage appears.