3Racing SAK-A570 Precision Front Suspension Mount for Sakura Advance 20M  [SAK-A570]

3RACING Advance_Front One Piece Suspension Mount Front - SAK-A570
Price:
USD$12.50
Brand:
3Racing
Model:
SAK-A570
Condition:
Brand New
Write a review

Race-oriented front mount for Sakura Advance 20M chassis

The 3Racing SAK-A570 is a single-piece front suspension mount developed to refine the front bulkhead stiffness on the Sakura Advance 20M. Its geometry control reduces dynamic deflection, helping maintain steering kinematics under cornering loads.

Technical benefits for setup and tuning

By stabilising the front assembly, the SAK-A570 allows tuners to dial in dampers and anti-roll settings with greater repeatability. The reduced compliance improves feedback for fine-tuning toe and camber response during high-speed maneuvers.

Application and fitment notes

Fully compatible with the Sakura Advance 20M mounting points, the 3Racing SAK-A570 integrates into standard setups. It is recommended to verify fastener torque and inspect mating surfaces to ensure consistent alignment and long-term stability.

How does this mount change roll centre behaviour?

The increased stiffness at the front bulkhead reduces unwanted movement, which can stabilise the effective roll centre and make roll characteristics more consistent under load.

Will fitting this affect steering geometry settings?

It preserves factory geometry but reduces flex-induced changes; small adjustments to tie-rod length or steering plate may be used to fine-tune toe-in after installation.

Recommended checks after installation?

Verify mounting fastener torque, confirm no interference with suspension arms, and perform a baseline setup run to re-evaluate damper and anti-roll bar settings.