3Racing SAK-CM111 Cero M Front Knuckle Arm Technical Upgrade  [SAK-CM111]

3Racing Cero M Chassis Front Knuckle Arm - SAK-CM111
Price:
USD$10.10
Brand:
3Racing
Model:
SAK-CM111
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

3Racing SAK-CM111 Technical Summary

The 3Racing SAK-CM111 Front Knuckle Arm is produced for Cero M chassis applications where consistent steering input and predictable response are required. Its construction focuses on repeatable behaviour under dynamic loads, aiding tuners who balance steering sensitivity with mechanical reliability.

Setup and Performance Notes

Engineered to enhance front-end feedback, the SAK-CM111 assists with tighter turn-in and maintained contact patch behaviour through corners. As a precision replacement, it integrates into standard steering geometries while allowing incremental adjustments during setup work.

What setup changes are recommended after fitting?

Recheck toe-in and caster settings and perform short validation runs. Minor steering trim and damper adjustments help integrate the SAK-CM111 into an existing setup.

Are there compatibility concerns with servo horn spacing?

The knuckle arm is designed for factory steering geometry; verify horn and link positions if using low-profile servos or custom servo mounts to avoid interference.

How does this affect cornering balance?

By increasing front-end stiffness and improving feedback, the SAK-CM111 can tighten turn-in and aid mid-corner stability. Adjust roll centre and shock settings to fine tune overall balance.