3RACING SAK-CS103 20T Centre Pulley Performance Part  [SAK-CS103]

3RACING Cero Sport Centre Pulley 20T For Cero Sport - SAK-CS103
Price:
USD$5.00
Brand:
3Racing
Model:
SAK-CS103
Condition:
Brand New
Write a review

Performance Centre Pulley for Cero Sport by 3RACING

The 3Racing 20T Centre Pulley is specified to restore and refine centre drive dynamics on the Cero Sport chassis. It promotes steady torque transfer and helps keep rotational loads consistent across the drivetrain.

Racing-Focused Attributes

Designed with setup stability in mind, this 20T pulley supports predictable behaviour during acceleration changes and directional transitions. It is a practical tuning component for drivers seeking repeatable results at the track.

Installation Notes for Tuners

As a direct replacement, installation aligns with the stock mounting points. Tuners should verify alignment and clearances, and confirm fastener torque to maintain optimal drivetrain geometry and reduce unwanted play.

What setup checks are recommended after fitting?

Check centre pulley alignment, runout, and fastener torque. Inspect mating gears for contact pattern and correct any sideplay before track use.

Is this part intended for high stress track use?

The pulley is designed to improve consistency under normal competition loads; for extreme or highly modified setups review the entire drivetrain for component compatibility.

Any tuning tips when swapping to this pulley?

After swapping, perform test runs to assess throttle response and adjust diff and suspension settings if needed to match the revised centre drive behaviour.