3RACING SAK-CS124/A Cero Sport Steering Step Screw - Race Setup  [SAK-CS124/A]

3RACING Cero Sport Steering Step Screw - SAK-CS124/A
Price:
USD$3.10
Brand:
3Racing
Model:
SAK-CS124/A
Condition:
Brand New
Write a review

Precise Steering Component for Setup

The 3RACING SAK-CS124/A is a targeted steering step screw for fine tuning the Cero Sport steering assembly. It is intended for model racers and tuners who require repeatable steering alignment during setup sessions.

Compatibility and Function

Designed to match the Cero Sport steering architecture, this step screw secures pivotal points within the linkage and aids in preserving measured steering geometry. It is a part to consider when refining handling balance.

Workshop Installation Guidance

During installation, ensure bearing faces and link anchors are clean to maintain precise contact. Fit the SAK-CS124/A using the correct driver and verify steering travel and centring as part of your setup routine.

Will this affect toe or ackermann settings?

The screw itself secures linkage points; correct fitment preserves existing toe and ackermann geometry. Any change usually stems from worn link ends rather than the step screw alone.

How should I verify setup after fitting?

Check steering centring and full lock symmetry on a setup stand or with the car on the bench, then confirm behaviour on a short test run to ensure no binding under dynamic loads.

Is this part useful for tuning consistency?

Yes, swapping in a fresh SAK-CS124/A can remove minor play and help achieve repeatable steering response, which is valuable when iterating setup changes.