3Racing SAK-D512 14T Bevel Gear Competitive Replacement  [SAK-D512]

3RACING Sakura D5S Parts 14T Metal Bevel Gear (90 degree) - SAK-D512
Price:
USD$5.60
Brand:
3Racing
Model:
SAK-D512
Condition:
Brand New
Write a review

Race-Tuned 14T Metal Bevel for Sakura D5S

The 3Racing 14T metal bevel gear targets drivers seeking tighter drivetrain feedback and improved durability under competitive loads. Precision tooth geometry helps maintain consistent backlash, which matters when optimising gear ratios and handling balance.

Technical Highlights

  • Material: Metal construction chosen for wear resistance and dimensional stability
  • Compatibility: Produced to match Sakura D5S gearbox interfaces
  • Performance: 14-tooth profile delivers steady engagement and reduced slop
  • Application: Best used in tuned setups where gear consistency affects lap times

How does the 14T affect gear ratio tuning?

The bevel tooth count contributes to final drive ratio when paired with specific pinion and spur combinations. Use known pinion sizes to calculate gear ratios and confirm top speed and acceleration tradeoffs.

What setup checks should be done after fitting?

Verify shaft runout, set proper mesh with minimal clearance, and inspect bearings. Reassess gear temperature after a measured test run to ensure no binding.

Is this gear suited for heavy duty or high torque motors?

Metal bevels handle higher torque than plastic counterparts, but confirm gearbox bearings and motor torque do not exceed the gearbox design limits to avoid secondary failures.