3Racing SAK-D5609 Aluminum Rear Bulkhead for Sakura D5S - Race Tuned  [SAK-D5609]

3RACING Sakura D5S Aluminum Rear Bulkhead - SAK-D5609
Price:
USD$18.80
Brand:
3Racing
Model:
SAK-D5609
Condition:
Brand New
Write a review

3Racing SAK-D5609 Rear Bulkhead Technical Overview

The 3Racing SAK-D5609 Aluminum Rear Bulkhead is produced to tighten rear chassis tolerances on the Sakura D5S platform. Machined aluminium construction reduces deflection under load, maintaining intended suspension geometry and ensuring repeatable handling characteristics for setup comparison. The component is dimensionally accurate to match OEM attachment points.

Performance and Tuning Benefits

Increased stiffness at the rear bulkhead lowers chassis compliance, which aids in consistent diff behaviour and predictable roll characteristics. This facilitates more precise tuning of damping and anti-roll components when optimising drift or circuit setups.

Installation Notes for Competitive Use

Install using correct torque values to avoid stress concentrations. Verify alignment with rear hubs and suspension arms after fitting. For track use, inspect fasteners and mating surfaces between sessions and apply light thread locker where vibration may induce loosening.

Is this bulkhead suitable for competition setups?

Yes, it is intended for drivers seeking consistent handling; it supports repeatable setup adjustments under race conditions.

Any recommended changes to diff settings?

Reduced chassis flex can change diff feedback; small incremental adjustments to preload or oil weight are advised when first testing the aluminium bulkhead.

What inspection routine is suggested for racers?

Check screw torque and mating surfaces before each event, and inspect for any wear or fretting where the bulkhead contacts the chassis or suspension mounts.