3Racing SAK-D5627/RE Sakura D5 Rear Graphite Shock Tower - Race Setup  [SAK-D5627/RE]

3RACING Sakura D5SGA Graphite Rear Shock Tower - SAK-D5627/RE
Price:
USD$15.00
Brand:
3Racing
Model:
SAK-D5627/RE
Condition:
Brand New
Write a review

Race-Focused Rear Shock Tower for Setup Precision

The 3Racing SAK-D5627/RE graphite rear shock tower delivers a stiffer rear mounting point to improve chassis feedback during aggressive tuning. Its graphite composition reduces compliance compared to stock plates, allowing finer adjustment of roll and traction characteristics without adding unnecessary mass.

Consistent Rear Geometry Under Load

With reduced flex, suspension behaviour becomes more repeatable lap to lap, which helps you isolate damper and spring changes for quicker setup decisions. That consistency is critical when chasing small gains in competitive layouts.

Direct Fit for Fast Track Changes

Manufactured for the Sakura D5 mounting pattern, the SAK-D5627/RE installs using standard hardware and aligns with existing shock positions. This direct fit keeps pit time low so you can iterate setups between runs.

How does this affect tuning strategy?

Expect a firmer rear baseline; tune damping and anti-roll balance to compensate. The reduced flex lets you make smaller, more predictable setup changes.

Is there a change in shock mounting geometry?

The part retains standard Sakura D5 shock positions, so geometry changes are minimal. Focus on damper rates and spring selection to exploit the increased rigidity.

Who should fit this part?

Serious club and regional racers who want a more consistent rear platform for tuning will benefit most; it complements iterative setup work and data-driven adjustments.