3Racing SAK-D6824/RE Sakura D6 74mm Red Turnbuckle Race Spec  [SAK-D6824/RE]

3RACING Auper D6 Steering C-FRP Red Turnbuckle 74mm - SAK-D6824/RE
Price:
USD$11.30
Brand:
3Racing
Model:
SAK-D6824/RE
Condition:
Brand New
Write a review

Racing-Focused Steering Link for Setup Precision

The 3Racing 74mm Red Turnbuckle is manufactured for the Sakura D6 as a focused upgrade for competitive chassis setup. Constructed from carbon fiber reinforced plastic, it balances reduced mass with the durability needed for repeated track use. The 74mm length integrates with standard Sakura D6 geometry to allow fine toe and steering trim without altering suspension baseline.

What setup benefits does the 74mm length deliver?

The 74mm length offers a stable steering ratio that helps reduce twitchiness while allowing precise toe changes for improved corner entry and mid corner balance.

Recommended checks after installation?

Verify thread engagement and ball end seating, then confirm toe with a gauge. Recheck after initial runs and adjust as part of setup iteration for consistent lap times.

Is this part suited to aggressive track conditions?

It is intended for circuit use where steering precision matters. Inspect the C-FRP for any damage after impacts and replace if structural integrity is compromised.