3Racing SAK-F54A Racing Spacer for SAKURA FF EVO  [SAK-F54A]

SAKURA FF EVO M5 x 6.5 x 2.5 Brass Spacer For KIT-FFEVO - 3Racing SAK-F54A
Price:
USD$5.00
Brand:
3Racing
Model:
SAK-F54A
Condition:
Brand New
Write a review

Technical spacer solution for competitive SAKURA FF EVO setups

The 3Racing SAK-F54A brass spacer is manufactured to fit the KIT-FFEVO chassis with tight tolerances, offering a reliable spacer for fine tuning. Its brass construction helps keep positional repeatability between runs, which is key for consistent setup work.

Racing-focused material benefits

Brass delivers predictable wear characteristics and dimensional stability under repeated load cycles. The M5 x 6.5 x 2.5 dimension provides exacting clearance for critical mounting points, helping to reduce setup variables during race preparation.

Setup and installation recommendations

For tuning use, verify spacer location with precision tools and install with consistent torque settings. Check for endplay and lateral movement after fitting; once validated, the 3Racing spacer aids in maintaining a repeatable baseline for further adjustments.

How does this spacer affect baseline setup tuning?

The spacer standardises local component spacing, reducing unwanted variation so baseline toe, camber and kick-up readings are more repeatable between runs.

Should I pair brass spacers with specific fastener torque values?

Use consistent torque values appropriate to the chassis fasteners to avoid distortion. Note torque specifications from the chassis manual and tighten in a controlled sequence for even seating.

Are there common tuning locations where this spacer is most effective?

This spacer is useful at mounting points where precise vertical or lateral clearance affects steering geometry or suspension mounting. Use it where small, repeatable changes help dial in handling.