3Racing SAK-F71A M5 Brass Spacer - Racing Setup Component  [SAK-F71A]

SAKURA FF EVO M5 x 6.5 x 1mm Brass Spacer For KIT-FFEVO - 3Racing SAK-F71A
Price:
USD$5.00
Brand:
3Racing
Model:
SAK-F71A
Condition:
Brand New
Write a review

Race-Oriented Fitment for the SAKURA FF EVO

The 3Racing SAK-F71A M5 x 6.5 x 1mm brass spacer is engineered for tuners who demand predictable handling from the SAKURA FF EVO. Use it to fine tune component stack heights and reduce unwanted play that can compromise turn-in consistency.

Precision Brass for Stable Setup Calibration

Manufactured to tight tolerances, the brass spacer provides a stable reference point within the assembly. Its material properties offer a balance between rigidity and wear resistance, allowing repeatable adjustments during setup sessions.

Compatibility and Installation Notes

The SAK-F71A fits the SAKURA FF EVO stack layout with exact 6.5 x 1mm dimensions. When installing, verify thread engagement and concentric seating to avoid introducing side loads that could affect bearing life or steering geometry.

How does spacer thickness influence steering roll?

Spacer thickness alters stack height and can slightly change camber and steering pack behaviour. The 1mm thickness is useful for incremental tuning without major geometry shifts.

Are there recommended torque values for M5 fittings?

Torque should be sufficient to prevent loosening while avoiding overloading small fasteners. Use progressive tightening and check alignment; consult your chassis manual for specific torque specs.

Can this spacer be used as part of a precision tuning kit?

Yes, the SAK-F71A works well in a precision tuning approach where small, repeatable adjustments are needed to refine handling for different tracks and tyre compounds.