3Racing SAK-MG07 Sakura Mini MG Precision Main Shaft Spacer M4 x 6 x 6.9mm  [SAK-MG07]

Sakura Mini MG RC CAR Main Shaft Spacer M4 x 6 x 6.9mm For KIT-MINI MG - 3Racing SAK-MG07
Price:
USD$1.90
Brand:
3Racing
Model:
SAK-MG07
Condition:
Brand New
Write a review

Race-Oriented Shaft Spacing for Sakura Mini MG

The 3Racing Sakura Mini MG RC Car Main Shaft Spacer is engineered for drivers who tune stack height and axial play on KIT-MINI MG platforms. Use these spacers as a controlled shim to refine shaft alignment and drivetrain behaviour.

Dimensions and Setup Impact

Rated at M4 x 6 x 6.9mm, the spacer provides consistent clearance values that help stabilise bearing loads and reduce unwanted lateral movement. Small changes to stack height can affect handling balance and drivetrain efficiency.

Installation Notes for Tuners

When installing the 3Racing SAK-MG07 spacer, ensure exact seating to maintain repeatable setup data. Verify free rotation and measure endplay; adjust spacer arrangement incrementally when dialing in handling or reducing friction losses.

How does spacer thickness change handling?

Altering spacer thickness shifts bearing preload and side play. Thinner stack can reduce friction but may increase lateral movement; thicker stack can stiffen the assembly. Make incremental adjustments and log results.

Can I use this spacer for track setup experiments?

Yes. Use the spacer to fine tune shaft clearance during setup changes, then test lap times and component temperatures to evaluate gains or drawbacks.

What checks should I perform after swapping spacers?

Check shaft runout, bearing rotation, and any axial play. Monitor for noise or heat build up and remeasure stack height to confirm consistency with your setup notes.