3Racing SAK-U403_V2/BK - Sakura Ultimate Front Suspension Mount (Competition Grade)  [SAK-U403_V2/BK]

3RACING Sakura Ultimate 7075 Aluminum Front Suspension Mount FF+1.5 Ver.2 - SAK-U403_V2/BK
Price:
USD$12.60
Brand:
3Racing
Model:
SAK-U403_V2/BK
Please kindly input your name and email address, we will inform you once we have the restocking.
Write a review

Competition-Oriented Front Suspension Mount for Sakura Ultimate

The 3Racing SAK-U403_V2/BK is produced for racers tuning Sakura Ultimate chassis, employing 7075 aluminium to deliver a balance of stiffness and low mass. The FF+1.5 Ver.2 geometry is intended to stabilise front-end alignment under dynamic loads, supporting consistent steering characteristics during aggressive driving.

Material Choice for Reliable Track Performance

7075 aluminium is selected for its high yield and fatigue resistance relative to standard alloys, offering durable behaviour under repeated impacts and load cycles. This supports predictable chassis response when adjusting suspension geometry for specific track conditions.

Setup Benefits and Tuning Notes

Fitted to the Sakura Ultimate platform, the 3Racing SAK-U403_V2/BK refines the front mounting locations to permit finer adjustments of camber, caster and steering linkages. For best results, confirm fastener torque and recheck alignment after initial test runs.

What are the expected gains in alignment stability?

The FF+1.5 Ver.2 layout reduces unwanted flex in critical mounting points, improving repeatability of alignment settings and reducing variance lap to lap.

Any special setup advice after installing this mount?

After installation, verify camber and caster angles, then perform short validation runs. Small adjustments to toe and damper tuning may be necessary to match the new front-end stiffness.

Is thread locking recommended on fasteners?

Use a medium strength thread lock on steel fasteners where movement is possible. Re-torque after initial runs to ensure secure clamping without over-stressing parts.