3Racing SAK-A563 Race Graphite Knuckle Arm Plate for Sakura Advance 20M  [SAK-A563]

3RACING Sakura Advance 20M Graphite Knuckle Arm Plate - SAK-A563
Price:
USD$7.60
Brand:
3Racing
Model:
SAK-A563
Condition:
Brand New
Write a review

Steering Response and Structural Control

The 3Racing Sakura Advance 20M Graphite Knuckle Arm Plate, model SAK-A563, is manufactured to enhance steering precision on the Sakura Advance 20M chassis. The graphite component increases system stiffness while minimising additional mass, enabling crisper steering inputs and more predictable transient behaviour during aggressive lap work.

Tuning Benefits for Competitive Setups

Engineered for direct fit to Sakura Advance 20M mounting patterns, the knuckle arm plate improves the repeatability of steering geometry under load. Its graphite construction offers a balance between rigidity and vibration damping, which assists in maintaining consistent toe and response when iterating setup changes at the track.

What should I check after installation?

Verify steering geometry, confirm bolt torque is even and within safe limits for graphite, and run measured test laps to note any change in steering balance.

How does this plate affect tunability?

Increased front-end stiffness can make steering more responsive to link length and servo settings, so expect to fine tune toe and steering endpoints when integrating this part into a race setup.

Is additional reinforcement required?

For normal racing use the graphite plate functions without extra reinforcement; monitor mounting interfaces and replace hardware if signs of wear appear during high mileage testing.