3Racing WH-33 Sakura D4 Competition Drift Tire 26mm  [WH-33]

3RACING Sakura D4 26mm Polycarbonate Drift Tire - WH-33
Price:
USD$7.60
Brand:
3Racing
Model:
WH-33
Condition:
Brand New
Write a review

Technical Overview of 3Racing WH-33 for Sakura D4

The 3Racing 26mm Polycarbonate Drift Tire WH-33 is specified for the Sakura D4 chassis to provide repeatable drift dynamics during practice and competition. The polycarbonate construction delivers a firm but consistent contact behaviour, enabling tuners to dial in suspension and steering geometry without variable tyre compliance. The 26mm width produces a defined contact patch that aids predictable yaw characteristics.

Material and Performance Characteristics

Utilising a high-stiffness polycarbonate compound, the WH-33 offers improved resistance to abrasion and thermal softening compared with softer rubber alternatives. This helps maintain consistent lateral slip throughout extended runs, reducing lap-to-lap variance so you can evaluate setup changes with confidence.

Fitment and Setup Notes for Sakura D4

The WH-33 is configured for direct fitment to standard Sakura D4 wheel interfaces, allowing rapid tyre changes during testing. When setting up, consider wheel offset and optional thin foam support to fine tune sidewall support and achieve the desired transient response.

What tuning variables interact most with WH-33 tyres?

Roll centre, toe angle and rear toe-in interact with tyre slip characteristics; small adjustments will alter entry and mid-drift behaviour noticeably with the WH-33.

Should I run inserts or leave the tyre unsupported?

In most cases these polycarbonate tyres run without inserts; use thin foam inserts only to increase rim support if sidewall collapse is observed during high-load transitions.

How to evaluate wear patterns during setup sessions?

Monitor inner and outer edges for asymmetric wear and compare changes after adjusting camber, toe or differential to quantify setup effects on tyre contact.